Selecting Destination Via Post Code - JVC KD-NX10 Manuel D'instructions

Navigation operation
If a definite entry is given, the system
switches to the Road/ Centre entry. If
there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
The location distinguishing list is dis-
played if the selection is ambiguous.
Select the required location using the
right rotary control and press the
control to confirm.
The program returns to the Road or Cen-
tre Entry.
If there are no roads or only the centre is
available for a particular town, the unit
will switch directly to the Route menu.
122
Selecting destination via post
code
The destination can also be selected via
the town's post code.
Select the destination's
POST CODE
by turning the right rotary control
and press to confirm the selection.
Using the right rotary control
the post code for the destination and
press for more than 2 seconds to con-
firm the entry. To confirm, the small
tick can also be selected and the
right-hand rotary control
briefly.
The display then shows either the desti-
nation corresponding to the post code or,
if the post code is shared among several
towns, a list containing these towns.
Select the required location using the
right rotary control
confirm.
If more than 9 locations share the same
post code, the display will show the lo-
cation input menu instead of the above-
mentioned list. In that case, the town
name is to be entered as described in
, enter
"Entering a destination" on page 121.
The program returns to road or centre
entry. If there are no roads in the select-
ed town or only the centre can be select-
ed, the unit will switch directly to the
pressed
route menu.
and press to