Setting The Fader; Setting The Balance; Linear Adjustment; Adjusting The Volume Of The Subwoofer Or Centre Speaker - JVC KD-NX10 Manuel D'instructions

Setting the fader

Press the button and then the
multifunction button.
Use the right-hand rotary control
to achieve the desired fader setting.

Setting the balance

Press the button and then the
multifunction button.
Set the desired balance level using the
right-hand rotary control

Linear adjustment

The tone adjustments for the current sig-
nal source (i.e. FM) can be reset to a
mid-level.
Briefly press the
press multifunction button
briefly -
Tone reset ?
Press the
again.
Adjusting the volume of the
subwoofer or centre speaker
Press the
multifunction button.
.
Use the right-hand rotary control
achieve the desired subwoofer volume
setting.

Switching loudness on/off

Press the
button. Then
will appear.
With multifunction button
can select either Loudness on (
Loudness off (
Note:
Loudness is switched off in MW, LW
multifunction button
and SW wavebands.
button and then the
to
General operation
button and then the
multifunction button.
you
ON ) or
OFF ).
115