Safety Warning - SCANGRIP CANVIK CENTER Instructions D'utilisation

Masquer les pouces Voir aussi pour CANVIK CENTER:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
GB
WARNING
Always check carefully that the jaws are correctly positioned!
PLEASE PAY ATTENTION TO TEXT WITH THIS SYMBOL.
THE INFORMATION IS IMPORTANT FOR YOUR SAFETY

SAFETY WARNING

Working safely with this tool is only possible when the operating and safety information are read
completely and the instructions contained therein are strictly followed. The manual shall be kept at
a known location easily accessible for operators and maintenance staff. ALWAYS WEAR PERSON-
AL PROTECTIVE EQUIPMENT LIKE PROTECTIVE CLOTHING, SHOES AND ETC. Concentrate your
attention on the work. Bear the potential risk of accidents in mind to ensure that they do not occur.
Use your common sense and do not operate the compressor if you are ill, tired or under the influ-
ence of alcohol or drugs. ONLY qualified and experienced persons should operate the compressor.
Check the unit for full functional capability before each use. If the functional capability
is not ensured or if damage is detected, STOP USING the compressor immediately and
contact your dealer!
Do not make any construction changes to the unit.
Use only suitable jaws for the springs. Ensure that the spring is positioned correctly in the
jaws. The centre line of the spring must be centred in both jaws.
When compressing the spring, the spring windings should not come in contact with each
other.
Only use air wrench with the supplied torque stick providing a 40 Nm torque limit.
Handle compressed spring with extreme care. Never drop or hit on compressed spring,
since this can cause serious injury.
Use only for spring types mentioned in the operating instruction.
Always keep the workplace clean and tidy.
Do not use the compressor for other purposes than it was designed for and DO NOT OVER-
LOAD the compressor.
Before and during the clamping process as well as after each operation, make sure, that the
spring is correctly seated in the compressor.
Do not lean over the compressor, when in use, to make sure that even in case the spring
releases unintendedly it will not hit the user.
Do not leave compressed spring unattended.
For indoor use only.
Store the compressor in a dry place.

Publicité

Table des Matières
loading

Table des Matières