SCANGRIP CANVIK CENTER Instructions D'utilisation page 6

GB
HOW TO MOUNT THE SPRING ON A CAR
• STEP 1
Make sure that both jaws are correctly
mounted.
• STEP 2
Preload the coil spring compressor. Make
sure that the jaws are STILL correctly po-
sitioned after preload and that they cannot
slip off the compressor. (see figure 1).
• STEP 3
Place the spring compressor with spring in
a bench vice equipped for clamping round
objects and fixate it by clamping the jaw.
NEVER clamp on the spring. Tighten the vice
enough to prevent the jaw from rotating
during the compressing operation. DO NOT
clamp too tight, since this may damage the
jaw. Do not exceed the max torque of 40 Nm
as this could damage the compressor. STOP
compressing before the windings of the
spring touch each other. Do not continue to
drive when the upper or lower travel ends of
the spring compressor are reached. Please
always take care during the entire operation
and stand beside the compressor NOT in line
with the spring central axis to prevent injury
in case the spring releases unintendedly.
• STEP 4
Mount spring compressor on the vehicle at
the right position. SLOWLY and CAREFULLY
release the spring compressor. Make sure
that the spring is mounted correctly and
then remove the spring compressor.
Figure 1
Figure 2