For Your Safety; Use As Intended - SCANGRIP CANVIK BASIC Instructions D'utilisation

GB

FOR YOUR SAFETY

Working safely with this tool is possible only when the operating and safety
information are read completely and the instructions contained therein are
strictly followed. The manual shall be kept in a known location and be easily
accessible for operators and maintenance staff.
OPERATING INSTRUCTIONS
• Before each use, check the unit for full functional capability. If the functional capability is
not ensured or if damage is detected, the unit should not be used.
• When compressing the spring, neither the spring windings nor the jaws should come in
contact with each other, Fig.B
• The centre line of the spring must always be parallel to the compressing device, especially
for conical springs.
• Use only suitable jaws for the springs. The spring must rest securely within the outer rib
and the safety ridges. Take care that Sliding of the spring out of the jaws plates is not
possible.
• The bolts of the jaws must always be firmly tightened
• When using impact wrench do not exceed 120 Nm torque limit.
• For repair, use only original parts.
• Do not make any construction changes to the unit. Do not replace safety pin by a stronger
safety pin.
• Do not leave unattended when in use

USE AS INTENDED

The coil spring compressor is exclusively for compressing and expanding of
McPherson strut springs whereby suitable jaws must be used. Any other or
further use is considered not as intended.