Installation; Mounting The Appliance - KitchenAid KMCM 3800 Notice D'emploi

Installation

MOUNTING THE APPLIANCE

Follow the supplied separate mounting instructions when installing the
appliance.
PRIOR TO CONNECTING
Check that the voltage on the rating plate corresponds to the voltage in your
home.
Do not remove the microwave inlet protection plates located on the side of
the oven cavity wall.
They prevent grease & food particles from entering the microwave inlet channels.
Ensure the oven cavity is empty before mounting.
Ensure that the appliance is not damaged. Check that the oven door closes
firmly against the door support and that the internal door seal is not damaged.
Empty the oven and clean the interior with a soft, damp cloth.
Do not operate this appliance if it has a damaged mains cord or plug, if it is
not working properly, or if it has been damaged or dropped. Do not immerse
the mains cord or plug in water. Keep the cord away from hot surfaces. Electrical
shock, fire or other hazards may result.
Do not use extension cord:
If the power supply cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
AFTER CONNECTING
The oven can be operated only if the oven door is firmly closed.
The earthing of this appliance is compulsory.
The manufacturer will accept no responsibility for injury to persons, animals or
damage to objects arising from the non-observance of this requirement.
The first time the oven is switched on, you will be asked to set the language
and current time.
Follow the instructions under the headline "Changing settings" in this instructions
for use.
The appliance is ready to use after these two steps have been taken.
The manufacturers are not liable for any problems caused by the user's
failure to observe these instructions.
4