Start Protection / Key Lock; Doneness (Auto Functions Only); Stir Or Turn Food (Auto Functions Only) - KitchenAid KMCM 3800 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Start protection / Key lock

This automatic safety function is activated one minute after the oven has returned to "stand by
mode". (The oven is in "stand by" when the 24-hour clock is displayed or if the clock has not been set,
when the display is blank).
The door must be opened and closed e.g. putting food into it, before the safety
lock is released. Else the display will show "DOOR".

Doneness (Auto functions only)

Doneness is available in most of the auto
functions. You have the possibility to personally
control the end result through the Adjust doneness
feature. This feature enables you to achieve higher
or lower end temperature compared to the default
standard setting.
When using one of these functions the oven
chooses the default standard setting. This setting
normally gives you the best result. But if the food
you heated became too warm to eat at once, you
can easily adjust this before you use that function
the next time.
This is done by selecting a Doneness level
with the Up & Down buttons right after you have
pressed the Start button.

Stir or Turn Food (Auto functions only)

When using some of the Auto functions the
oven may stop (depending on the chosen program
and food class) and prompt you to STIR FOOD or
TURN FOOD.
TO CONTINUE COOKING:
Open the door.
• Stir or turn the food.
• Close the door and restart by pressing the
Start button.
DONENESS
LEVEL
High +2
Yields highest end temperature
High +1
Yields higher end temperature
Med 0
Default standard setting
Low -1
Yields lower end temperature
Low -2
Yields lowest end temperature
Note:
The Doneness can only be set or altered during
the first 20 seconds of operation.
Note: the oven continues automatically after
1 min. if the food hasn't been turned / stirred. The
heating time will be longer in this case.
10
E
FFECT

Publicité

Table des Matières
loading

Table des Matières