Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
Tools Needed
Phillips screwdriver
■
Measuring tape
■
Hand or electric drill (for wall cabinet installations)
■
1" (2.5 cm) drill bit (for wall cabinet installations)
■
Level
■
Flat-blade screwdriver
■
Parts Needed
UL Listed or CSA Approved conduit connector
■
UL Listed wire connectors
■
Warming Drawer Deflector Kit (for ovens installed
■
above a warming drawer)
Order Part Number W10536339 for stainless steel
30" 76.2 cm) kit
Order Part Number W10727416 for black stainless steel
30" (76.2 cm) kit
To order, see the "Assistance or Service" section
of the Use and Care Guide.
2
BUILT-IN OVEN SAFETY
Your safety and the safety of others are very important.
INSTALLATION REQUIREMENTS
Tools and Parts
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Flush Installation Kit (for Single and Double installed at flush
■
installation)
Order Part Number W10752683 for stainless steel
30" (76.2 cm) kit
Order Part Number W10752682 for black stainless steel
30" (76.2 cm) kit
To order, see the "Assistance or Service" section of the Use
and Care Guide.
Parts Supplied
#8-14 x
/
" (1.9 cm) screws - single ovens (2), double
3
■
4
ovens (4)
#8-18 x
/
" (9.5 mm) screws - bottom vent (2)
3
■
8
#8-18 x
/
" (6.4 mm) screws - bottom vent trim (4)
1
■
4
#8-18 x
/
" (9.5 mm) screws - double oven feet (4)
3
■
8
Bottom vent
■
Rear feet - double oven (2)
■
Front feet - double oven (2)
■
Check local codes. Check existing electrical supply. See the
"Electrical Requirements" section.
It is recommended that all electrical connections
be made by a licensed, qualified electrical installer.
Publicité
Table des Matières
