Caster Assembly; Wet/Dry Vac Assembly - Workshop WS0400SS0 Mode D'emploi

1. Insert the caster stem into the socket
of the caddy, as shown (4 places).
2. With a slight twisting motion, push on
the caster until the ball on the caster
stem is inserted all the way into the
socket. You will hear the ball snap into
the socket and the caster will swivel
easily when positioning is correct.
3. Turn the drum upright.
Remove Power Head
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate Vac
with any parts damaged or missing.
Grasp the drum latches on both the right
and left side of the power head. Slowly
pull the drum latches away from the
drum. Lift the power head off the drum.
Place the lid assembly of the Vac upside
down.

CASTER ASSEMBLY

WET/DRY VAC ASSEMBLY

Caster
Caster
Stem
Caster
Ball
Socket
Dust
Drum
7
Pull Up
And
Lift Out
Power Head
Assembly
Drum
Latch (2)
Drum