Wet/Dry Vac Assembly; Dust Drum Assembly; Insert Hose - Workshop WS1100CA0 Manuel Du Propriétaire

Masquer les pouces

Table des Matières

Les langues disponibles

Dust Drum Assembly

1. Slide the dust drum into the front of the

Wet/Dry Vac unit when Filter assembly

is complete. Position the dust drum

wheels into the drum area slots and

glide into place.

NOTE: When reinstalling the dust drum

and Filter support assembly, ensure that

the front of the dust drum is flush with the

lid and motor cover assembly. The dust

drum should fit snugly into place. There

are two pins in the Wet/Dry Vac unit that

must fit into the slots in the drum. This

ensures proper alignment. The dust drum

must be installed properly to ensure the

Wet/Dry Vac functions correctly.

2. Pull the two latches on the front of the

dust drum up and over the latch

holders and press down firmly until

they snap in place. If the pins from the

lid and motor cover assembly are not

aligned, the latches will not lock.

WARNING: To avoid ingesting

debris or water in the impeller and

damaging Vac, never operate

without Filter support assembly in

place.

Insert Hose

Insert the push button end of the hose

assembly into the inlet of the Vac. The

hose should snap into place. To remove

the hose from the Vac, press the release

button in the hose assembly and pull the

hose out of the Vac inlet, as shown.