Caster/Caster Foot Assembly; Wet/Dry Vac Assembly - Workshop WS1200VA0 Mode D'emploi

CASTER/CASTER FOOT ASSEMBLY

With the power head and lid assembly
removed from the drum, and the drum
upside down on the floor:
1. Insert the 4 caster feet into the bottom
of drum, as shown on the 4 locations.
2. Push firmly on the caster foot until the
foot is flush with bottom of the dust
drum.
3. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
4. With a slight twisting motion, push on
the caster until the ball on the caster
stem is inserted all the way into the
socket. You will hear the ball snap into
the socket and the caster will swivel
easily when positioning is correct.
5. Turn the drum upright.
1. Line up front of power head assembly
with vacuum port located on the front
of the drum, as shown.
2. Place power head assembly on top of
drum.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Push down on top of the drum latch
areas to cause the flexible locking tabs
to hook onto the drum channel.
5. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off. (See inset).
6. For the WS1600VA0, rotate both drum
latches down until you hear them snap
over lip of the drum.

WET/DRY VAC ASSEMBLY

Caster
Foot
Hole
Dust
Drum
WS1200VA0
Out
Flexible
Locking Tab
Push Down
6
Caster
Caster Stem
Caster Ball
Pin
Drum
Top
Assembly
Push Down
Pull Out
Flexible
Locking
Tab
Drum
Channel