PCE PMI 3 Mode D'emploi page 10

8. Language selection
The software has been designed to allow the user to choose between different languages. The langu-
age is changed from the menu. To open the language selection menu, select the Language item in the
operating menu and confirm by pressing "ON". Select the language and confirm by pressing "ON". To
protect against accidental changes, it is necessary to confirm the action To confirm the change press the
"ON" button once again, press "SELECT MATERIAL" to cancel. Language settings are stored in the
memory, even if the batteries are removed.
9. Restore factory settings
Factory reset will undo all the changes of the alarm thresholds. To restore the factory settings, select the
"Factory Settings" (Werkseinstellungen) item from the menu and confirm by pressing the "ON" button.
To protect against accidental changes, it is necessary to confirm the action To confirm the change press
the "ON" button once again, press "SELECT MATERIAL" to cancel.
10. Power supply
The PCE-PMI 3 hygrometer is powered by two AA batteries. You may use either disposable or re-
chargeable batteries. The Battery status indicates the battery charge level. If an empty battery icon is
displayed, replace the batteries. Batteries should be replaced with a new set of batteries of the same
kind. Do not use a rechargeable battery in combination with a disposable battery or a partially dischar-
ged battery with a full battery.
The figure below shows the location of the batteries in the battery compartment.
PCE Deutschland GmbH
D-59872 Meschede | Im Langel 4
Tel: +49 (0)2903-97699-0 | Fax: +49 (0)2903-97699-29
www.pce-instruments.com