Christopeit Sport E 2000 Notice De Montage Et D'utilisation page 19

STEP 7:
Installation of the footrests (98) at footrest holder
(45).
1. Push the right footrest (98R) onto the right foot-
rest holder (45R). Adjust the holes in the parts so
that they are aligned.
2. Push the carriage bolts M6x45 (94) from above
through the holes. Put on a washer (96) from the op-
posite side and screw on Handgrip nut (97) and tight-
en firmly.
3. Install the left footrest (98L) on the left footrest
holder (45L) as described in 1. – 2. (Note: The right
and left footrests (98) can discern by the edges of the
longitudinal sides of the footrests. The high edges of
the footrests (98) must point inwards (towards the
main frame. The position adjusted in this way should
always be equal at both sides. The positions can
change as desired at all times by removing the car-
riage bolts (94) and sliding the footrests on the foot-
rest brackets to get a more or less fat movement.)
STEP 8:
Attach the computer (1) at support (3).
1. Put the plug of connection cable (2) into the plug
from computer (1) backside.
2. Insert the plug of pulse cables (51) to the jacks of
the computer (1) and attach the computer (1) to top
monitor bracket of support (3) with screws (67). Use
screws from backside of computer. (Attention: En-
sure that the cable loom are not crunched or pinched
during installation.) Remove the protective film from
the display if present.
3. Mount computer cover set (37+38) to the sup-
port (3) and secure with screws (31+35).
STEP 9:
Checks
1. Check the correct installation and function of all
screwed and plug connections. Installation is thereby
complete.
2. When everything is in order, familiarise your-
self with the machine at alow resistance setting and
make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe
place as these may be required for repairs or spare
parts orders becoming necessary later.
19
GB