Christopeit Sport E 2000 Notice De Montage Et D'utilisation page 17

STEP 3:
Installation of the footrest holder (45) with connect-
ing tubes (7).
1. Push the axle (26) into the middle position at
handlebar support (3) and put one wave washer (5)
and the connecting tube right (7R) onto the right ax-
les' end (26). Put on the screw (6) a spring washer
(12) and a big washer 8//32 (10) and tighten it frm-
ly. (Note: Right is specifed as viewed standing on the
machine during training.)
2. Install the left connection tube (7R) incl. all ad-
ditionally required parts on the left hand side of the
machine as described in 1.
3. Push the footrest holder (45R) at the connecting
tube (7R) and adjust the holes in the tubes so that
they are aligned.
4. Push the axle bolt (50) through the holes and
tighten the footrest holder (45R) at connection tube
(7R) with washers (14), spring washers (12) and
screw (6) frmly. (This connection point has to move
easily. So please don't tighten the screw too much.)
5. Install the left footrest holder (45L) incl. all ad-
ditionally required parts on the left hand side of the
machine as described in 3. – 4.
6. Mount plastic cover set (44+46) to front side of
footrest holder (45L+45R) and secure with screws
(31+90) for each side.
STEP 4:
Installation of the handgrip (41) at connecting tubes
(7).
1. Push the handgrip bars (41L+41R) onto the con-
necting tubes (7L+7R) and adjust the holes in the
tubes so that they are aligned. (Note: the handgrip
bars must be aligned after assembly so that the up-
per ends are inclined outwards (away from the sup-
port (3)).
2. Push the bolt M8x40 (39) through the holes and
tighten the handgrip bars (41) with curved wash-
ers (13) and distance ring (40) at connection tubes
(7L+7R) frmly.
17
GB