Software Update; Technical Data; Ec Certificate - Cristec BAT-MON-3.5 Manuel Utilisateur

7

SOFTWARE UPDATE

To update the software of the battery monitor, a micro-SD card is required. After receiving the software, the file must be
copied to the previously empty micro-SD card (without folder, top level).
To update, insert the micro-SD card into the micro-SD card slot on the back of the monitor and disconnect the power
supply from the battery monitor. Then the power is turned on and the screen shows that new software has been
detected and installed automatically. During the update process the progress is displayed. When finished, the power will
be disconnected and the micro-SD card removed.
If the monitor starts normally after inserting the micro-SD card, no micro-SD card has been detected or the software is
up-to-date.
8

TECHNICAL DATA

Monitor
Supply voltage
Current consumption
Relay contact
Dimension
Shunt
Current consumption
Resistance
Voltage measuring range (+1) and (+2)
Current carrying capacity
Current measuring range
Temperature measuring range
Dimensions
Connections
9

EC CERTIFICATE

This device complies with the requirements of the European directives:
Directive 2011/65/EU (RoHS)
Directive 2014/30/EC (Electromagnetic Compatibility):
NF EN 61000-6-1 : 2007
Electromagnetic compatibility (EMC) - Part 6-1: generic immunity standards - for residential, commercial and light
industrial environments.
NF EN 61000-6-3 : 2007
Electromagnetic compatibility (EMC) - Part 6-3: generic emission standards - for residential, commercial and light
industrial environments.
DC 8-32 V
100 mA at maximum display brightness, 65 mA in sleep mode
1A / DC 30V / Dielectric strength: AC 1000V
L 105 x W 105 x D 40 mm
45 mA
0.1 mΩ
DC 0-35V, resolution 30mV, accuracy 0.25%
300A, 600A 1 min., 1500A 0.5 sec.
-600 to +600A, resolution 10mV, accuracy 0.5%
External sensor : -15 to 60°C, resolution 1K, accuracy 1K
L 118 x W 40 x H 65 mm
Bolt M8
37