Monitor; Relay - Cristec BAT-MON-3.5 Manuel Utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The configuration of the shunts is displayed in the setup with serial (SN) and identification (ID) number:
2 : Shunt #1 settings
(see section 4.3 for battery
mode)
4.2
M
ONITOR
After pressing the "Monitor" symbol, the adjacent image appears. The following settings can now be made:
On page 2 the following settings are available:

Relay

4.2.1
According to "Relay Control" field, the potential free relay output can be used to :
Either control of a gen-set depending on the SoC (state of charge) ; or
Either control a switch based on voltage to switch On and Off a source according to an operating window.
Note : It is possible to test the relay function by pressing Manual test.
Language
Brightness max.
Brightness Auto
Stand by
Relay
Alarm Buzzer
Buzzer Auto Off
LIN Network
Date / Time
Change PIN
Device Info
Load Factory data
1 : Monitor settings
(see section 4.2)
3 : Shunt #2 settings
(see section 4.4 for energy
mode)
FR / GB / DE
50 - 100%
On / Off
1 - 300 seconds / Off is 0 sec.
see section 4.2.1
On / Off
Off buzzer delay
see section 3.4
Time and date settings
0 to 9999 (1234 by default)
Hardware and software version
Monitor is reset to factory status
30

Publicité

Chapitres

Table des Matières
loading

Table des Matières