Set-Up; Pin Code To Access Set Up - Cristec BAT-MON-3.5 Manuel Utilisateur

If the installation only uses one shunt, the system is ready to use. If more than one shunt is used, please follow
step 3.
Step 3 : Connect the supply of the next shunt. This shunt will appear in the bottom row. Press button #2 or #3
in order to assign the ID. The shunt will shift to the selected row (bottom right picture). Select the NAME by
pressing the corresponding areas.
Repeat the process if a third shunt is used.
4

SET-UP

4.1 PIN C
ODE TO ACCESS SET
To access setup, press
-
UP
on the main screen. A PIN code is required to access setup (by default 1234).
29