Installation Instructions - Kuppersbusch KI9820.0SF Mode D'emploi

INSTALLATION INSTRUCTIONS

The installation must be performed by a qualified electrical contractor.
How to stick the gasket:
The gasket supplied with the hob prevents the intrusion of liquids into the cabinet below.
It's installation has to be done carefully, in conformity with the following drawing.
Aeration
Fitting - installing:
•
The cut out sizes are:
KI9820.0SR
KI9820.0SF
•
Ensure that there is a distance of 50 mm between the hob and the wall or sides.
•
The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed with plenty of
space on either side. There may be a wall at the rear and tall units or a wall at one side. On the other side,
however, no unit or divider must stand higher than the hob.
•
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, the
laminate coatings and the glue used to fix them, must be able to resist temperatures of up to 100 °C.
•
Do not install the hob at the top of a non ventilated oven or a dishwasher.
•
Ensure under the bottom of the hob casing a space of 20 mm to ensure good air circulation of the electronic
device.
•
If a drawer is placed under the hob, avoid putting into this drawer flammable objects (for example: sprays) or
non heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect the cut out edge,
apply a coat of varnish or special sealant. Particular care must be taken when applying the adhesive joint
supplied with the hob to prevent any leakage into the supporting furniture. This gasket ensures a good seal
when used in conjunction with smooth work top surfaces.
•
The safety gap between the hob and the cooker hood placed above must comply with the recommendations
of the hood manufacturer. In the case of no instructions, a distance of 760 mm minimum should apply.
•
The connection cord should not be subjected to any mechanical constraint.
•
WARNING: Use only hob guards designed by the manufacturer of the cooking appliance or indicated by the
manufacturer of the appliance in the instructions for use as suitable or hob guards incorporated in the
appliance. The use of inappropriate guards can cause accidents.
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection tape (3).
A B
898 mm 518 mm
900 mm 520 mm
47
E F
750 mm 490 mm
750 mm 490 mm
H
53 mm
53 mm