Installation Instructions - Kuppersbusch K 5 Serie Notice D'utilisation

INSTALLATION INSTRUCTIONS

The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carefully, in conformity of the following drawing.
Aeration
Fitting - installing:
• The cut out sizes are:
KI8520.0SR
KI8520.0SE
KI8520.0WR
KI8520.0SF
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or divider must stand higher than
the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
• To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good air
circulation of the electronic device.
A
798 mm 518 mm
800 mm 520 mm
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).
B E
750 mm
750 mm
38
F H
490 mm 54 mm
490 mm 54 mm