Automatic Cooking; Stop&Go Function; Recall Function - Kuppersbusch KI9820.0SF Mode D'emploi

•
Automatic stop at the end of the cooking time:
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking, press the key [ 00 ].
•
Egg timer function :
Example for 29 minutes :
Action
Activate the hob
Select« Timer »
Set the units
Validate the units
Set the tens
Validate the tens
After a few seconds the control light stops blinking.
As soon as the selected cooking time is finished the timer display will blink [ 00 ] and a sound will be heard.
To stop the sound and the blinking, press the display [ 00 ]. The hob switches off.

Automatic cooking

All the cooking zones are equipped with an automatic "go and stop" cooking function. The cooking zone starts at full
power for a certain time, and then reduces automatically its power to the pre-selected level.
•
Start-up :
Action
Zone selection
Full power setting
•
Switching off the automatic cooking :
Action
Zone selection
Power level selection
Stop&Go function
This function stops the entire hob's cooking activity temporarily and allows restarting with the same settings.
•
Startup/stop the pause function :
Action
Enter on the Menu
Engage pause
Stop the pause

Recall Function

After switching off the hob [
•
cooking stages of all cooking zones (Power)
•
minutes and seconds of programmed cooking zone-related timers
•
Keep warm function
The recall procedure is following:
•
Press the key [
•
Press on the "SLIDER" under the [ II ] light
The previous settings are again active.
Control panel
press display [ ]
press 3s [CL] display
slide on the "SLIDER" to [ 2 ]
press display [ 20 ]
slide on the "SLIDER" to [ 9 ]
wait 2 seconds
Control panel
press display [ 0 ] selected
slide on the "SLIDER" and keep on
the power level
Control panel
press on the zone
slide on the "SLIDER"
Control panel
Press menu key [
Press on the "SLIDER" under the
[ II ] light
Press 3s on the "SLIDER" under the
[ II ] light
], it is possible to recall the last settings.
]
Display
zone control lights are on
[ 00 ]
[ 2 blinking ] [ 0 fixed ]
[ 2 fixed ] [ 0 blinking ]
[ 2 fixed ] [ 9 blinking ]
[ 29 ]
Display
[ 0 ] and control light on
the power level is blinking with [ A ]
Display
the power level is blinking with [ A ]
[ 0 ] to [ 9 ]
Display
] the menu is displayed
[ II ] on display
Previous setting on display
37