gdw 1103 Instructions De Montage page 5

Mitsubishi Space Star
1999 - ....
Ref.
Fitting instructions
1) Remove the bumper. Attention: there are 2 bolts in the corners of the bumper which you can reach via the
trunk (these are covered with self-adhesive foam).
2) Place mounting piece (f) against the left outer side of the chassis beam with points (A) and (B) on the
provided screw-thread holes. Insert all bolts and washers, but do not tighten them.
3) Place the tow bar so that points (D) fit the points (D) of the already mounted piece. Points (A) and (B) of
the tow bar fit the provided screw-thread holes in the right side of the chassis beam.
Point (C) comes over the towing ring, place the mounting pieces (e) in between the tow bar and the
towing ring as filling, insert the necessary bolts, washers and nuts and tighten everything
4) Before replacing the bumper an incision has to be made.
Standard ball T44: incision visible, see drawing 1
Detachable ball T36: incision not visible
5) Install the (*) and also tighten firmly.
Composition
1 tow bar reference 1103
1 ball T44 K007
2 bolts M12 x 70
2 safety nuts M12
1 security shackle (800053)
6 bolts M10x1,25 x 30
1 bolt M12 x 70
3 safety washers M12
2 nuts M12
2 bolts M12 x 30
4 washers 30x10,5x2,5
6 safety washers M10
1 mounting piece (f)
2 mounting pieces (e)
All bolts and nuts: quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
1103
: see drawing 2
(*)
(*)
(*)
(*)
(A-A'-B)
(C)
(C-D)
(C-D)
(D-D')
(A'-B)
(A-A'-B)
(D-D')
(C)
firmly.