Safety Features; Cleaning And Care - Royal Sovereign HCE-220 Manuel Du Propriétaire

SAFETY FEATURES

This Heater is fitted with an overheat protection switch (thermal cut-out) which will power off the appliance
automatically in case of overheating. Should this occur, unplug the appliance and allow to cool fully for approximately 30
minutes.
Follow the operation instructions to restart the appliance after removing the source of the overheating (poor ventilation,
item covering the heater etc.). The Heater should function normally. Should the problem persist, please contact Designer
Habitat Customer Services.
To avoid damage and to regulate the temperature, this Heater is fitted with a thermostatic safety device. The safety
device will activate and cut out the power to the Heater once a certain temperature is reached. The Heater will start again
once the temperature has lowered.
The Heater is also fitted with a tip switch which will cut off the power to the Heater if it is knocked over. Should this
happen, disconnect at the mains and allow to cool fully before attempting to move the Heater. Inspect the Heater for
damage. If - and only if - the Heater is free from damage, plug back into the mains. The Heater should function normally.

CLEANING AND CARE

IMPORTANT: Turn off the Heater. Switch off the ON/ OFF Rocker Switch and disconnect from the power socket. Wait for the
Heater to be completely cool before cleaning.
Vacuum-clean air vents and grilles to remove dust from these areas.
To remove dust on external surfaces, wipe the Heater with a damp (not wet) lint-free cloth rinsed in hot soapy water only.
CAUTION: Do not use any harsh detergents or abrasive cleaners.
WARNING! Do not spray with any liquids or submerge in liquid or water.
WARNING! Do not attempt to clean the interior of the Heater. Do not attempt to open the casing at any time. There are no
user-servicable parts.
Remove the Filter (6) and clean regularly. To remove the Filter, locate the 3 small screws on the rear of the Heater, remove
the Filter Cover and Filter and rinse the Filter using clean water. Leave to dry completely before replacing.
CAUTION: Ensure the Filter is completely dry before returning it to the Heater. Failure to follow this instruction could
damage the product, invalidating any warranty.
8