Operation - Royal Sovereign HCE-220 Manuel Du Propriétaire

OPERATION

Using The Remote
NOTE: Pull away the small plastic tab located on the bottom of the Remote (7) to activate the battery.
The Remote has 6 functions:
NOTE: The functions are non-effective when the heater is in standby mode except for the Power Button.
1. POWER - To power the unit on/off (in between standby and on).
NOTE: This will only work when the ON/OFF Rocker Switch (1) is on.
NOTE: When the Heater is powered off, the fan will run for approximately 60 seconds before powering off completely.
2. MODE - Changes the power settings:
• Fan-only • Low power- 750W
3. TIMER - The timer function allows you to set the length of operation for up to 9 hours for automatic switch off.
Pressing the 'TIMER' button increases the length of operation by 1 hour each time the button is pressed.
Once the timer has been set, it will count down the hours in 1 hour intervals; when the time reaches zero, the Heater will
automatically switch off and enter standby mode.
Pressing the 'TIMER' button once more when the display shows 9 hours will reset the Heater to run continuously.
4. OSCILLATING - Switches the oscillating function on or off.
5. UP - Increases the temperature in 1°F increments.
When increasing the temperature using the
your finger over it for a prolonged period. Holding your finger over the
LED Display to show the temperature in °C.
Should this happen, simply hold your finger on the
6. DOWN - Decreases the temperature in 1°F increments.
Using The Heater
Use the ON/OFF Rocker Switch (1) on the rear of the Heater to switch it on.
Press the 'POWER' button and the Heater will switch on from standby and the LED Display (4) will show the room
temperature. The Heater will begin to heat up to the preset temperature of 77°F.
NOTE: If the room temperature is 2°F higher than the preset temperature, then only the fan will operate. The Heater will
switch back on again once the room temperature drops 2° to 3°F.
If the Heater is not operated for 3 seconds, the LED Display will show the room temperature.
The Heater will cycle on and off to maintain the preset temperature. This is not a fault with the appliance.
• High power - 1500W
button (circled above), press the button repeatedly rather than holding
button for 2 seconds to revert back to °F.
6
button for more than 2 seconds will set the