Connecting Light Cable; Operation; Powering Up Lightsource; Lamp Life Hours Display - Cuda surgical Elite 1000 Mode D'emploi

When using medical isolation transformer, be sure to check the
NOTE
power ratings.
Ensure that the power cord is connected to the main power with three prong plug
(USA use UL2601-1 rated isolation transformers and/or power strips only).
Nearby radio or TV units may subject this equipment to radio interference.
To avoid adverse electromagnetic effects, DO NOT operate this equipment
near RF energy equipment.
CAUTION
5.2 CONNECTING THE LIGHT CABLE
Connect the fiberoptic cable to endoscope or other instrument and then plug the cable
illuminator end tip into the appropriate port of the turret on the front panel.

6. OPERATION

6.1 POWERING UP THE LIGHTSOURCE
To operate the illuminator: First attach the illuminator to the instrument or headlamp.
Turn on the rear power switch. Turn on the lamp switch. The fan will start. The indicator
on lamp switch will light.
6.2 LIGHT BRIGHTNESS DISPLAY AND CONTROL
The light brightness adjustment enables the user to obtain a brighter or dimmer
illumination of the object of observation.
Adjust the light intensity by sliding the intensity control knob from left (off) to right
(brightest) as shown by the ramp graphics on the dimmer control.
NOTE The brightness control operates a progressive mechanical shutter. The lamp is
running at full power if the power switch is on no matter where the brightness
control is set.

6.3 LAMP LIFE HOURS DISPLAY

The hour meter shows the total elapsed running time of the unit.

7. CLEANING and DISINFECTION

NOTE Always disconnect the power cord before cleaning the system and while
unit is drying if wet-wiped.
Disinfection agents should be commercially available cleansers commonly used for
disinfection of electronic equipment cabinets in hospitals, such as ethyl or isopropyl
®
LIT-217 CUDA SURGICAL
(English)
transformer
Rev. A
Date of Revision:
Page 9 of 66