End Of Product Life; Troubleshooting - Cuda surgical Elite 1000 Mode D'emploi

9.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to
manufacturer at the end of product life.
10.

TROUBLESHOOTING

Problem
The power indicator (refer
to 4.1) is not lit.
The power indicator is lit,
but Xenon lamp will not
ignite.
11. CHART OF MEDICAL ELECTRICAL DEVICE SYMBOLS USED
®
LIT-217 CUDA SURGICAL
(English)
Solution
A. Check that the AC power cord is properly connected.
B. Check the circuit breakers. If necessary, reset.
C. Power input switch is in the off position
A. Check to make sure lamp cartridge is seated properly.
B. Check that the lamp door is secured.
C. Check hour meter; if lamp hours exceed the rated
lamp life, replace the lamp (refer to 9.1).
Manufacturer
Date of manufacture (YYYY-MM-DD)
"Authorized Representative" in the European Community
Caution, consult accompanying documents
Caution: Federal law restricts this device to sale by or on
the order of a licensed healthcare practitioner
Consult Instructions for Use
CE mark
Type BF Applied Part
Not dispose in general waste,
Caution: Hot Surface
Caution: Dangerous Voltage
Product Safety Mark
Rev. A
Date of Revision:
Page 12 of 66