Important Product Information; Information To The User - Shure ANIUSB-MATRIX Guide De L'utilisateur

Important Product Information

The equipment is intended to be used in professional
audio applications.
Note: This device is not intended to be connected
directly to a public internet network.
EMC conformance to Environment E2: Commercial
and Light Industrial. Testing is based on the use of
supplied and recommended cable types. The use
of other than shielded (screened) cable types may
degrade EMC performance.
Changes or modifications not expressly approved by
Shure Incorporated could void your authority to operate
this equipment.
Industry Canada ICES-003 Compliance Label: CAN
ICES-3 (B)/NMB-3(B)
Authorized under the verification provision of FCC
Part 15B.
Please follow your regional recycling scheme for
batteries, packaging, and electronic waste.

Information to the user

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
Specifications
Analog Connections
Input (1) 3-pin block connector (Active
Balanced)
Output (1) 3-pin block connector
(Impedance Balanced)
USB Connections
(1) USB 2.0, Type B
Single port carries 1 input and 1 output
channel (Summed mono)
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment to an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
The CE Declaration of Conformity can be
obtained from: www.shure.com/europe/
compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
This product meets the Essential Requirements
of all relevant European directives and is eligible
for CE marking.
The CE Declaration of Conformity can be
obtained from Shure Incorporated or any of
its European representatives. For contact
information please visit www.shure.com
Network Connections (Dante Digital Audio)
(1) RJ45
4 input channels, 2 output channels
Polarity
Non-inverting, any input to any output
Power Requirements
Power over Ethernet (PoE), Class 0. (PoE Plus
compatible).
12