Shure ANIUSB-MATRIX Guide De L'utilisateur page 10

Reset
The reset button is located inside a small hole
in the rear panel. Use a paperclip or other
small tool to press the button.
There are two hardware reset functions:
Network reset (press button for 4-8
seconds)
Resets all Shure control and audio
network IP settings to factory
defaults
Full factory reset (press button for
longer than 8 seconds)
Restores all network and web
application settings to the factory
defaults.
Installation and Rack Mounting
Two mounting solutions are available for installing the Audio Network Interface:
CRT1 19" Rack Tray (optional accessory): Supports up to 3 devices; mountable in a rack
or under a table
Single-unit Mounting Tray (included accessory): Supports a single device for mounting
under a table
Securing the Devices
Use the included screws from the mounting hardware kit to secure the Audio Network
Interfaces. Audio Network Interfaces can be mounted to face either direction. Insert the
screws from the bottom in the appropriate holes, according to the following diagrams:
Align the holes as shown for securing a single device in the
single-unit mounting tray
10
Software Reset Options
To simply revert settings without a
complete hardware reset, use one of the
following options:
Reboot Device: In the web application
(settings > factory reset), there is a
Reboot Device button, which simply
power-cycles the device as if it were
unplugged from the network. All
settings are retained when the device is
rebooted.
Default Settings: To revert audio
settings back to the factory configuration
(excluding Device Name, IP Settings,
and Passwords), select Load Preset and
choose the default settings preset.