Alecto AVM-500 Mode D'emploi page 74

GB
• Besides that, the sounds and images on the
monitor are not exactly simultaneous.
MAINTENANCE:
• Only clean the AVM-500 with a moist cloth; never
use chemical cleaners. Before any cleaning, you
must disconnect the power adapters.
ENVIRONMENT AND DISCARDING:
• The packaging of this video monitor can
be discarded as waste paper. However,
we advise you to save this packaging so
you can adequately protect the devices for
transportation.
•
as normal household waste.
• In case the video monitor is being replaced,
please return it to your supplier; they will
guarantee environment-friendly processing.
PROBLEMS:
• no image, no sound:
– are the monitor and camera switched on?
(battery charged, battery full?)
– is the monitor within range of the camera?
– is the image and sound are not disabled
because no sound is being detected? (VOX)
– is the volume at the monitor set to 0 (off)?
– are the camera and monitor registered to
each other?
• If the above is all in order, remove the adapters
from the wall sockets, take the rechargeable
battery out of the monitor, wait at least one
minute and then reconnect everything. Now,
switch the monitor and camera back on.
• If you still receive no images or sound, please
contact the customer service of Alecto via
internet www.alecto.nl
74
Faulty or exhausted batteries or battery
packs should be taken to your local
depot for small chemical waste or to
dedicated battery collection points.
Never dispose of batteries or battery
packs