Alecto AVM-500 Mode D'emploi page 69

indicator starts flashing after several seconds
to indicate that the camera is now searching for
the monitor.
6. After several seconds the images of the new
camera will appear in the display of the monitor.
Repeat these instructions if the registration process
doesn't succeed the first time.
To select a camera:
1. Open the menu on the monitor by pressing the
button and use the
the option .
2. Use the
and press the
3. Use and
ber and press the
4. After several seconds the monitor will show the
images of the selected camera.
In the right upper corner of the display the number
is shown of the camera that is currently viewed.
Camera SCAN:
At the above instruction 2, select the option
and press the
The images and sound of all registered cameras
are now played via the monitor, in order and 10
seconds for each camera.
Attention: The unit does NOT automatically
switch to a camera where sound is being
detected.
To remove a camera:
Cameras that are defect or no longer being used
must be removed from the system as follows:
1. Open the menu on the monitor by pressing the
button and use the
the option .
2. Use the
and press the
and buttons to select the option
to select the desired camera num-
button.
button to enable the SCAN mode.
and buttons to select the option
and buttons to select
button.
and buttons to select
button.
GB
69