Alecto AVM-500 Mode D'emploi page 68

GB
Sirene:
Use and
from the loudspeaker of the camera and select
OFF to stop this signal (the sirene does NOT stop
automatically)
The volume is fixed and cannot be changed by you.
Keep in mind that the sound of the sirene is
returned to the monitor via the microphone
of the camera. In this case, you may want to set the
sound of the monitor to level 0 (= sound off).
Multi-camera:
Introduction:
You may register up to a maximum of 4 cameras
on the
AVM-500 monitor. When multiple cameras are reg-
istered to the monitor, you can manually switch to
another camera or have the images of all registered
cameras automatically shown one after the other.
Separate cameras are available via the Alecto ser-
vice department via www.alecto.com (order number
'AVM-5001').
To register new cameras:
1. Connect the power adaptor to the camera and
slide the ON/OFF switch at the rear to the ON
position.
2. Open the menu on the monitor by pressing the
button and use the
the option .
3. Use the
4. Use the
available free camera number and press the
button.
5. Press and hold the PAIRING button at the bot-
tom of the new camera until the green ON/OFF
68
to select ON to start the sirene-signal
and
and press the
and
and
buttons to select the option
button.
buttons to select the next
buttons to select