2. Safety information
The safety information is related to both the user protection and the system protection. The user should carefully read
the safety information included in this chapter to ensure the safe use of the system. If in doubt, contact the Technical
Assistance Service (contact information in Section 0.3).
The following symbols are located along the manual to indicate:
Access to the equipment interior: Only the authorized technical service can access the interior of the equipment
to carry out maintenance and repair tasks other than the usual installation and consumable replacement tasks described
in this manual. The warranty does not cover activities other than those related to the intended use of the equipment;
neither does it cover activities related to an improper handling of the equipment or incidents caused by personnel
unrelated to the manufacturer's technical service.
Electrical connections: Check the compliance of the Electrical requirements described in Section 4.1 of this
manual.
Feed water and hydraulic connections: Check the compliance of the Feed water requirements and the
Hydraulic connections described respectively in Sections 4.2 and 4.8 of this manual.
Deviations from the feed water requirements can result in a deterioration of the system components and/or a lower
performance of the equipment.
Environmental conditions: Check the compliance of the Environmental conditions described in Section 4.3 of
this manual.
Consumables: Follow the equipment warnings and the guidelines in this manual to replace the consumables of
the system. Use original consumables. The use of consumables from another source may result in damage to the
equipment and the loss of the warranty. If the consumables are not installed immediately, check the consumable
storage instructions in the equipment documentation delivered with the equipment.
The equipment warranty is 12 months.
Attention: Danger or important information.
Attention: Risk of electric shock.
5/31