Symbols On The Screen And Meaning; Keyboard Symbols And Meaning - Wasserlab Micromatic Mode D'emploi

10.2 Symbols on the screen and meaning

Symbol Meaning
Tank: When the three lines flash consecutively, the equipment is in production mode.
When all three lines are lit simultaneously, the tank is full and the equipment is in stand-by
mode.
Inlet solenoid valve open
Numerical value of the measurement.
Equipment in production mode
OT Equipment configuration OT: Equipment with atmospheric deposit
Pretreatment warning: Pretreatment cartridges [1] and [2] must be replaced. See Section
14.1.
Resin warning: Deionization resin cartridges [3] and [4] must be replaced. See Section
14.1.
Water cut: The water inlet to the equipment has been interrupted. See Section 14.1.
The conductivity probe does not measure correctly. See Section 14.1.
Configuration menu.
µS/cm Unit of conductivity.
Unit of temperature.
Calibration menu (only accessible by the technical assistance service).
RESET Setting the pretreatment counter (in hours) to 0 in the configuration menu.
Pre-treatment counter (in hours) in the configuration menu.

10.3 Keyboard symbols and meaning

MODE/ESC
ENTER


Cancellation of actions / Access from the main menu to the
configuration menu or vice versa.
Acceptance of actions / Start the modification of values in
configuration menu.
Scroll into the different screens of the configuration menu /
Decrement of values.
Scroll into the different screens of the configuration menu /
Increment of values.
19/31