After Operation; Turning Off The Tool - Prebena PKT-8-PR100 Traduction Des Instructions De Service D'origine

After operation

After operation
After operation or extended interruptions in operation, carry out the
steps described below.

Turning off the tool

▶ Turn off the tool by pressing the ON/OFF button (1) on the control
panel for at least 2 seconds:
✓ If the green LED (2) is no longer lit, the tool is turned off. All
the other LEDs are also not lit.
The tool turns itself off automatically after 10 minutes if it has
not been activated in any way.
56
WARNING
Accidental triggering may result in severe or fatal
injuries.
▶ Do not point the fastener driving tool at yourself,
other people or animals.
▶ Turn off the tool after operation is complete and
empty the magazine.