After Operation; Disconnecting The Compressed Air Supply; Emptying The Magazine - Prebena 1GP-ALK35 Notice Originale

After operation

After operation, or during long periods when the tool is not in use,
perform the steps described below.

Disconnecting the compressed air supply

 Switch off the compressor.
 Pull the quick coupler of the compressed air hose away from the
handle.
The quick coupler is now released.
 Remove the compressed air hose from the connection on the
tacker.
The compressed air contained in the tacker escapes audibly.

Emptying the magazine

 Open the magazine as described from page 17 onwards.
 Remove the remaining fasteners.
 Ensure that there are no single fasteners in the magazine and
shot channel.
 Close the magazine as described from page 18 onwards.
After operation
23