Using The Crossbar Hook; Venting The Fastener Driving Tool - Prebena PKT-8-PR100 Traduction Des Instructions De Service D'origine

Operation

Using the crossbar hook

The fastener driving tool has a crossbar hook (chevron hook) by
which you can briefly fasten the tool to a roof batten or similar object.
The crossbar hook is located on the bottom of the fastener driving
tool.
To be able to suspend the fastener driving tool, the crossbar hook
must be turned to the side.
▶ Press the crossbar hook in a little (1):
▶ Then turn the crossbar hook to the side (2).
✓ Now you can suspend the fastener driving tool.

Venting the fastener driving tool

You can vent the fastener driving tool at any time as long as there is
no compressed air cartridge connected. This may be necessary for
example
• to remove condensation
• before fault rectification (before removing jammed nails, etc.).
▶ To vent the tool, press the red venting button (1):
54