Setting Down The Fastener Driving Tool - Prebena PKT-8-PR100 Traduction Des Instructions De Service D'origine

Reloading nails
The magazine has a blank safety device.
This prevents you from being able to trigger the fastener driving tool
if there are only 5–8 nails in the magazine.
▶ Load new nail strips (see page 40).

Setting down the fastener driving tool

The fastener driving tool has a specified resting position. The tool
has three padded areas on the right side for setting it down:
1 Padded area under the handle
2 Rear padded area
3 Tool tip padded area
▶ If work will be interrupted for a few minutes, set the fastener
driving tool down.
▶ Always set the fastener driving tool down so it is resting on the
three padded areas.
Operation
53