Metabo HPT NP 35A Manuel D'instructions Et De Sécurité page 19

Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a metabo HPT authorized service center for assistance.
PROBLEM
Nailer operates, but no nail is driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping nails
Intermittent feed.
Nails jam.
Driven nail is bent.
Drives properly during normal
operation, but does not drive fully at
faster nailing speeds.
CHECK METHOD
Check for a jam.
Nailer feeder damaged?
Pushing spring weakend or
damaged?
Check for proper nails.
Check air pressure.
Check position of nailing depth
adjuster.
———
Driver blade worn?
Piston O-ring worm or damaged?
Check air pressure.
Check position of nailing depth
adjuster.
Check for proper nails.
Nailer feeder damaged?
Pushing spring weakend or
damaged?
Piston O-ring worn or damaged?
Check for proper nails.
Driven blade worn?
Check inside diameter of air hose.
CORRECTION
Clear a jam page 17.
Replace nail feeder.
Replace pushing spring.
Use only recommended nails.
Increase air pressure.
(Do not exceed 100 psi (6.9 bar 7
kgf/cm ))
2
Readjust per page 15.
Use metabo HPT pneumatic tool
lubricant.
Contact metabo HPT for
replacement.
Reduce air pressure.
(Adjust 64–100 psi
(4.4–6.9 bar 4.5–7 kgf/cm
Readjust per page 15.
Use only recommended nails.
Replace nail feeder.
Replace pushing spring.
Contact metabo HPT for
replacement.
Use only recommended nails.
Contact metabo HPT for
replacement.
Use larger air hose.
English
))
2
19