Threading The Machine; Preparing The Bobbin; Setting Spool Of Thread On Spool Pin; Bobbin Winding - Singer C440 Manuel D'instructions

Threading the Machine

PREPARING THE BOBBIN

Be sure to use only SINGER
®
in this machine.
1. Pull the bobbin cover latch to the right and remove the
bobbin cover.
2. Lift up the bobbin from the machine.
Setting Spool of Thread on Spool Pin
See page 19.
Bobbin Winding
1. Hold thread in both hands and hook thread to the guide
from front opening.
2. Bring thread to the right and pass it through the thread
guide from the back side. Pass thread under the bobbin
winding tension disk in a clockwise direction, making sure
it is placed snuggly under the disk.
3. Insert thread through hole in bobbin and place the bobbin
on bobbin winder spindle.
4. Hold the end of the thread and push bobbin and spindle to
the right. The bobbin winding screen will appear.
5. Press the start/stop button to start winding.
6. After the bobbin winds a few turns, stop the machine by
pressing the start/stop button. Cut the thread next to the
hole on top of the bobbin. None of the thread end should
be left showing above the hole.
7. Start the machine again by pressing the start/stop button.
You can adjust winding speed by pressing "+" (faster) or "-"
(slower) button.
8. The bobbin winding will stop when the bobbin is wound
fully. Press the start/stop button to stop the machine. Push
the bobbin and spindle to the left.
9. Remove the bobbin from the spindle and cut thread with
the thread cutter.
Class 15 bobbins (transparent)
17