Removable Storage Compartment; To Open The Accessory Tray; To Remove/Attach The Removable Storage Compartment; Changing The Presser Foot - Singer C440 Manuel D'instructions

REMOVABLE STORAGE
COMPARTMENT
To Open the Accessory Tray
The accessories are stored in the tray of the removable storage
compartment. To open the tray, reach under the removable
storage compartment, then pull the lever located under the
removable storage compartment, while resting your thumb on
the top edge.
To Remove/Attach the Removable Storage
Compartment
Hold left side of the removable storage compartment and pull
to the left (DO NOT pull the lever for the accessory tray).
To attach, slide the removable storage compartment to the
right.

CHANGING THE PRESSER FOOT

For safety, turn off the power switch before changing the
presser foot.
The presser foot must be changed according to the stitch
or technique you sew. Information on sewing and sewing
techniques begins on page 21.
1. Turn the handwheel toward you until the needle is at its
highest position.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser foot
release lever toward you.
4. Place desired foot with its pin directly under the slot in
presser foot holder.
5. Lower the presser foot lifter and the presser foot will snap
into place.
Removing the Presser Foot Holder
When attaching presser feet that have their own shank, or
when cleaning the machine, you should remove the presser
foot holder.
1. Remove the presser foot.
2. Loosen the presser foot screw and remove the presser
foot holder.
3. To replace the holder, pull up the holder as far as it will go
from bottom of presser bar.
4. Tighten the presser foot screw securely using the
screwdriver.
NOTE: This sewing machine is a low shank model. When
shopping for optional SINGER
make sure they are designed for low shank models.
®
presser feet and accessories,
Accessories
8