When you return to the Sequence Screen, the last entered
letter will be shown on the left side of the LCD screen.
NOTE:
1.
If a letter is selected, which has a different base line (like "j"
or "g"), the width and length of other letters will be adjusted
to proportion automatically.
2.
The sequence can contain a maximum
of 40 patterns and letters. Message will
appear when you reach the limit.
Press the "✓" button.
Shifting the Cursor (Highlight)
The cursor position is the highlighted pattern or letter.
By pressing the Cursor buttons (a, b), cursor will shift up or
down.
The cursor is used to check selected patterns, insert patterns,
delete patterns or edit each pattern as described below.
NOTE: When the cursor is shifted to the top of sequence, it will
disappear. (c)
Checking Selected Patterns and Letters
As the length of the sequence increases, patterns and letters
will disappear from view on screen.
You can check patterns and letters by moving the cursor
upward or downward using the cursor buttons.
Inserting Pattern or Letter
Machine will insert a pattern or letter after the highlighted
pattern or letter.
Shift the cursor to highlight the pattern just before the desired
position.
To insert a pattern, select pattern number.
To insert a letter, press the Letter button and select or edit
letter as described on the previous page.
Deleting Pattern or Letter
1.
Shift the cursor to the pattern or letter you want to delete.
2.
Press the Delete button (d) quickly (less than 0.5 sec.).
Machine will delete the pattern or letter and cursor will
shift to next pattern or letter. (If it was last pattern or letter,
cursor will shift to previous pattern or letter.)
3.
If you want to delete all patterns and letters, press and
hold the Delete button 0.5 sec. or shift the cursor to the top
of sequence and press the Delete button.
When deleting all patterns, a pop up will
appear, press the "✓" button. Machine
will delete all selected patterns and
letters. To cancel, press the "X" button.
Sequencing
a
b
d
40
c
d