Threading The Machine; Preparing To Thread Machine; Setting Spool Of Thread On Spool Pin; Threading The Upper Thread - Singer 9910 Notice D'utilisation

THREADING THE MACHINE

A. PREPARING TO THREAD MACHINE
1. Raise the presser foot lifter.
2. Press the needle up/down button and set the
needle in up position.
(Keep this position until needle eye threading.)
Open the top cover and set spool as below.
B. SETTING SPOOL OF THREAD ON
SPOOL PIN
1. Pull up the left end of spool pin and set the
spool of thread on spool pin.
2. Set the spool cap on spool pin as far as it will
go.
a: Reverse spool cap direction according to the
size of spool.
b. Use the small spool cap when you use cross
wound thread. Leave small opening between
cap and spool as illustration.
C. THREADING THE UPPER THREAD
1. Hold thread in both hands and pass thread to
the guide from front opening.
2. Bring thread backward and pass through the slit
from right to left.
3. Bring thread to the left and pull down thread
toward you along the slit.
4. Pull up thread.
5. To thread the take-up lever, draw thread up and
bring thread back down again from right to left
along the slit.
6. Pull thread downward along the slit.
7. Draw thread through thread guide from right
side opening.
8. Pass through needle eye from front to back.
Refer to next page for instructions on how to
use needle threader.
28
9910EFSt.pm6
28 2003.9.10, 8:46 PM