Installation Of Accumulator / Battery Exemplified By A Battery Set; Initial Commissioning - KERN and SOHN MPE Serie Mode D'emploi

9.8 Installation of accumulator / battery exemplified by a battery set:

Remove battery compartment cover
Connect battery holder to housing
contact acc. to illustration
Insert battery holder
Insert batteries into battery compartment
and lock with battery compartment
cover.

9.9 Initial Commissioning

In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1). During this
warming up time the balance must be connected to the power supply (mains,
accumulator or battery) and be switched on.
The accuracy of the balance depends on the local acceleration of gravity.
The value of gravity acceleration is shown on the type plate.
MPE-BAPS-e-2121 20