Adjust The Column Tilt; Drilling In The Ceiling - Husqvarna DS150 Manuel D'utilisation

Adjust the column tilt

Loosen the locking screws for column tilt and set the
desired drill angle. Tighten the locking screws. Use the
feed handle. The column can be tilted 0-60°.
The angle indicator can be used for approximate
adjustment. If higher precision is required, alternative
measuring methods should be used.

Drilling in the ceiling

WARNING! Use a water collector to avoid
!
water penetrating into the machine. The
machine must be covered with plastic or
the like in order to prevent water
penetrating into the machine, but do not
cover the air intakes and air outlets.
ASSEMBLY
–
English 13