Important - PROUSER SUPER-BIKE Notice D'assemblage Et De Sécurité

FIXING OF THE BIKE CARRIER ON THE ROOF BAR OF THE CAR
Step 1
Put the bike carrier on the roof bar of the car. Make sure that the fixation-frame
(Bracket with two "arms") is right above the first (front) tube. Place the two
double slide screws from bottom to top over the tube of the roof bar and through
the holes of the fixation-frame. Put washer and plastic wing nuts on each screw
and tighten them so the bike carrier can not move on the tube anymore
Step 2
Right above the rear tube, you put the special assembly plate (pre-shaped for
the two tubes of the bike carrier). Place the double slide screw from top to
bottom through the holes of the assembly plate.
Mount the bottom plate against the
bottom of the tube and place the
screws through the pre-mounted
holes of the bottom plate. Put
washer and plastic wing nuts on
each screw and tighten them so the
bike carrier can not move on the
tube anymore

Important:

Please make sure that all wing nuts
have been well tightened and the
bike carrier can not move on the roof
bar.
The bike carrier is now ready for use!
21