PROUSER SUPER-BIKE Notice D'assemblage Et De Sécurité page 20

Step 2
Slide the two short, black straps through the little
slots in the plastic wheel holder. You need these
straps later for to fix the wheels of your bike.
Step 3
Move the fixation-frame (Bracket with two "arms") on the mainframe so there is
40cm between the fixation-frame and the end of the mainframe (see picture). If
necessary firstly loosen the two plastic wing nuts of the fixation-frame. Please
make sure that afterwards the these plastic wing nuts are well tightened again.
Step 4
Mount the black plastic rotary knob with the long screw and spring on the
mounting frame, through the pre-drilled holes (photo 1-3).
Then mount the lockable tog nut on the pivot screw on top of the mounting
frame (photo 4).
The bike carrier is now ready for fixing the roof bar of the car.
20