Prepare Cabinet Cutout - Bosch HMB Serie Manuel D'installation

Add tape (C) to side air duct (F) and attach to micro-
wave, being careful to align screw holes in top and rear
of side air duct (F) with holes in top air duct (F).
Secure side air duct (F) to top air duct (F) using two T-
20 Torx pan head bolts (B).

Prepare Cabinet Cutout

Prepare cabinet cutout according to figures 8-10.
Fold up baseplate tabs to approximately 95 degrees.
10
Align baseplate (I) with two tabs as shown and a center
line drawn or scribed on the cabinet bottom and visible
in center front slot.
Drill pilot holes and attach cabinet fixing brackets (G)
using two phillips flat head screws each side.
Note: A block of wood may need to be added behind
the cabinet front, flush with the cabinet opening, to
secure the bracket.