3.4. Manual Tune
You can manually tune to a particular channel/frequency. This can be useful while adjusting your
antenna to achieve the best possible reception and scanning a particular channel to update the
station list.
Press MENU > Manual tune then use the
/
buttons on the
remote control or rotate the TUNE knob on the unit to find a par-
ticular channel/frequency and press OK to confirm.
3.5. Now playing information
While a station is playing, the display shows its name and DLS
(Dynamic Label Segment) information broadcasted by the station
such as programme name, track title, album name, etc.
If the information has over 16 characters, it will scroll across the
display.
Each time you press the INFO button, the next set of information is displayed, cycling through: DLS
text, DLS Plus information (this is only displayed if broadcast by the station), signal strength, pro-
gramme type, ensemble name, channel number/frequency, signal error rate, bit rate, time and date.
3.6. Dynamic range compression (DRC)
This function reduces the difference between the loudest and qui-
etest audio being broadcast.
Effectively, this makes quiet sounds comparatively louder, and
loud sounds comparatively quieter.
Note: DRC only works if it is enabled by the broadcaster for a
specific station.
To change the DRC setting select MENU > DRC.
3.7. Factory Reset
A factory reset returns all user settings to default values, so that favorites, time/date and other in-
dividual settings are lost. To reset the device press MENU > System > Factory reset and confirm
with OK.
3.8. Language
The default language is German. If you would like to change the language, press MENU > System
> Language to choose between German, English, French and Dutch.
4. FM Radio Mode
FM mode receives analogue radio from the FM band and displays RDS (Radio Data System) infor-
mation about the station (if broadcasted).
4.1. Scan for Stations in FM Mode
To scan for the next available FM station press and hold
/
. The unit scans up/down through
the FM band frequencies, showing the current frequency on the display.
The scan stops when a signal is found. The unit can be set to stop at each station or only at stations
with a strong signal (for details see „4.4. Scan Settings" on page 25).
Alternatively, you can short press the
/
buttons to tune manually in 0.05 MHz steps.
English
24