3. DAB+ Radio Mode
Fully extend the antenna then switch on the DR 62 with
DAB button to switch between DAB and FM.
3.1. DAB Station Scan
The first time you power on the radio, it will scan for DAB radio stations automatically. It will display
and play the first station after the scan is done.
If no stations can be found and the display shows "No DAB Service", change the postion of the
antenna or the complete radio and perform a Scan again by long pressing the SCAN button.
3.2. Tune DAB Station
Press the arrow keys ◄/► to select another radio station from the channel list.
3.3. Station Information
Press the INFO button to switch between the displayed information. The following options are
available:
•
DLS (Dynamic Label Segmenting): Radio text broadcasted from the DAB station.
•
PTY (Programme Type): Popmusic, Talk, News etc.
•
Channel/Frequency – The frequency of DAB is displayed such as "11C 220.352MHz".
•
Audio info: The display shows the digital audio bit rate of the current reception.
•
Signal error: The signal strength is displayed graphically.
•
The signal strength and the battery level are displayed graphically.
•
Time/Date – The time and date are set automatically.
•
Ensemble name
•
Software version
3.4. Presets / Favorites
There are 10 presets each available for DAB and FM
If you would like to save a station to your favorite list, short press the FAV button. Use the arrow
keys ◄/► to select a desired preset slot 1-10. Confirm your selection by holding OK until the
display shows "saved".
To recall the preset station, simply press the FAV button briefly, use the arrow keys ◄/► to navigate
and press OK to confirm.
4. FM Radio Mode
Press the FM button to select FM mode.
4.1. FM Manual Scan
Press the arrow buttons ◄/► to change the frequency manually in 0.05MHz steps, long to quickly
search through the FM band. With a long press of the SCAN button, you can search for the next
available FM station.
4.2. Presets / Favorites
See chapter 3.4. on page 13
4.3. Radio Text
Press the INFO button to switch between the displayed information. The following options are
available:
•
RT (Radio text): Text broadcasted from the FM station
•
The signal strength and the battery level are displayed graphically.
. When the unit is turned on, press the
13