Start Preparations; Inserting The Batteries In The Transmitter - Reely 1530490 Blackster R7 2.0 FPV WiFi RtF Notice D'emploi

8. Start Preparations

a) Inserting the Batteries in the Transmitter
Remove the battery compartment lid (1) on the back of the transmitter. For this, you need to remove the two screws
(2) and lift off the lid.
Insert six mignon/AA size batteries with the correct polarity. Observe the corresponding icons in the battery
compartment (3). Attach the battery casing lid and screw it back on.
Operation of the transmitter with batteries is not recommended because of the lower cell voltage
(battery = 1.5 V, rechargeable battery = 1.2 V) and the self-discharge of rechargeable batteries. Quick
feedback of the transmitter on low charge status of the transmitter power supply would result.
Since the transmitter requires very little power, batteries will keep much longer. We recommend the use of
high-quality alkaline batteries.
Figure 1
43