Troubleshooting; Indicator Leds On Mower - Powerworks P3 Manuel D'utilisation

Troubleshooting

This section also presents some symptoms that can guide you if the mower does not work as expected.

Indicator LEDs on Mower

LED STATUS
1. Operating Flashing
(Green)
On
Off
2. Connectivity Flashing
(Blue)
On
Off
3. Security Flashing
(Yellow)
Off
4. Error Flashing
(Red)
Indicator LEDs on Charging Station
LED STATUS
Green On
Blue Flashing
Red Flashing
MEANING
Recovery mode
Mower in operation mode (charging, parked in Charging
station, paused, mowing or searching)
Mower stopped with Stop button on mower, safety key in
Disabled position, mower in error state or mower waiting for
PIN code.
Mower not ready for Bluetooth connection
Mower ready for Bluetooth connection with Mobile App
App
Mower not in "Power on mode"
PIN code authorization required
No pin required
Mower stopped with error
MEANING
Boundary wire and Charging station OK
Boundary wire broken or not connected
Electronic fault in charging station or power supply Unit
ACTION
Place the robot in charging station with a
mobile with the Powerworks tools App close
to the mower for software update of mower.
This can take up to 1 hour until the green LED
to stop flashing. If LED doesn't stop flash then
restart the robot outside the CS and try again.
If mower stopped with error the mower need
to be restarted with the Start button to allow
Bluetooth connection again
... via Mobile App.
No action required
Check the reason for the error and then restart
by pressing the Start button on the mower.
ACTION
No action required.
Check and repair boundary wire.
Please contact your dealer
POWERWORKSTOOLS.COM
Version 1 - 2020.12.30
EN
23